With a chrome finish, this oil suction gun is suitable for rapid draining or filling of oil and other non-corrosive liquids. Possessing a working pressure of 90psi/6.2bar and supplied with a flexible 275mm spout.

Features and Benefits

• 500cc capacity allows you to effectively drain or fill without having to release often
• Chrome finish is classic and aesthetically pleasing
• Comes with a 275mm spout for easy draining

Typical Applications
• Engineering
• Automotive

For use with Kennedy grease guns, these flexible nylon hoses are designed to improve access in confined spaces. Varying in length and bore size, each product possesses a 1/8" BSP connecting thread.

Features and Benefits
• Flexible nature makes the products suited for use in confined or awkward areas
• Available in a variety of lengths and bore sizes to suit your needs
• Manufactured from nylon for durability and flexibility

Typical Applications
• Automotive
• Engineering

This 1/8" BSP threaded, 4 jaw hydraulic connector is an effective way of allowing for the controlled flow of lubricants. Securely fastens the grease nipple when in use to ensure minimal slippage.





Features and Benefits


• Manufactured from steel for durability


• Securely grips the grease nipple while in use to control the flow of the lubricant


• Textured in places for easy gripping even with oily or greasy hands





Typical Applications


• Automotive


• Engineering


• Mechanics

Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.

Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost

Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)

Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot