Pump & Lubricants
Kennedy Lever Pump, 0.3L
Suitable for lubricants, diesel and non-corrosive liquids, this lever pump is constructed from a zinc chrome finish steel and is completed with a telescopic suction tube. Suitable for container sizes 60 and 205 litres, the innlet on the pump is 2" BSP and M59 x 5 male thread.
Features and Benefits
• Manufactured from steel for durability
• Zinc chrome finish protects against corrosion and wear and tear
• Can be used with both 60 and 205 litre containers making it a versatile product
• Is compatible with non-corrosive liquids and most lubricants
• Telescopic suction tube allows you to adjust the tube to suit your desired container
Typical Applications
• Automotive
• Engineering
Features and Benefits
• Manufactured from steel for durability
• Zinc chrome finish protects against corrosion and wear and tear
• Can be used with both 60 and 205 litre containers making it a versatile product
• Is compatible with non-corrosive liquids and most lubricants
• Telescopic suction tube allows you to adjust the tube to suit your desired container
Typical Applications
• Automotive
• Engineering
Download
Produk Lainnya
Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.
Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost
Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)
Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot
Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost
Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)
Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot
For use with Kennedy grease guns and all other hydraulic grease equipment.
Our submersible pumps often go to work where centrifugal, progressive cavity, lobe, and chopper pumps have failed. Their unique design and our state-of-the-art technology tackle even the toughest applications with ease.
For use with Kennedy grease guns and all other hydraulic grease equipment.