Cantilever pumps are ideal for moving abrasive materials and slurries, as only a portion of the pump is located under the fluid. The seals, bearings, bushings, and suction check valves are all outside of the liquid, preventing the material from degrading or interfering with them.

Our cantilever pumps are designed by our engineering team that specializes in handling the toughest pumping jobs. They set the standard for pumping slurries and abrasive materials.

Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.

Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost

Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)

Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot

Available to suit 25 or 205 litre containers, these syphon pumps are an efficient way of controlling and dispensing a host of fluids. Comprised of a flexible plastic outlet and semi-rigid inlet tubes, the hand pumping units incorporate one-way valves. Suited for use with petrol and diesel as well as with non-corrosive liquids. All tubes can be cut to length and are fitted with a threaded bung. Model SPS/25 has a squeeze action and models SPS/205 and SPH/205 have a plunger-type action.

Features and Benefits
• Tubes can be cut to your desired length to meet your requirements
• Suitable for use with petrol, diesel and all non-corrosive liquids
• Available to suit three sized containers
• Flexible nature allows you to manipulate the pump to your desired position

Typical Applications
• Engineering
• Aquatics
• Automotive

RP250

Used for dispensing lubricants and disel, this cast iron pump with a steel suction tube and spout is the easy way to control the flow of said liquids. Suitable for container size of 200 litres, the pump possesses an inlet of 2" BSP and M59 x 5 male thread.

Features and Benefits
• Cast iron pump with steel suction tube and spout making for a hardy product
• Suited for use on a 200 lite capacity barrel
• With a 980mm tube to easily dispense liquids when necessary

Typical Applications
• Suited for controlling the flow of fluids in a 200 litre barrel