This 1/8" BSP threaded, 4 jaw hydraulic connector is an effective way of allowing for the controlled flow of lubricants. Securely fastens the grease nipple when in use to ensure minimal slippage.





Features and Benefits


• Manufactured from steel for durability


• Securely grips the grease nipple while in use to control the flow of the lubricant


• Textured in places for easy gripping even with oily or greasy hands





Typical Applications


• Automotive


• Engineering


• Mechanics

• No close tolerances
• Pulsation-free flow
• Laminar flow
• Non-impinging, preventing degradation
• Does not emulsify or damage delicate and shear sensitive products
• Includes in-line, close-coupled, side-by-side, over-under, and self-priming configurations

Our sump and dry fit pumps are the clog-free, low cost, long-lived option that outperforms progressive cavity, centrifugal, lobe, and chopper pumps in even the toughest installations. These pumps are not only powerful but incredibly versatile.

Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.

Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost

Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)

Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot