Volt-tested to ensure safety on or near electrical equipment up to 1000V AC or 1500V DC, this range of VDE insulated screwdrivers is suited for electrical use. The blades are insulated with magnetic, parallel tips. Slotted head screws are the most commonly used screw. The tip of the screwdriver should be of the same width as the slot in the screw head and fill it as well, to minimise slipping. The product is finished with a high grip handle and is available in a range of sizes.

Features and Benefits
• Magnetised tips allow you to effectively hold fasteners in place to apply torque accurately
• Available in a range of sizes to suit your needs
• High grip handles ensure maximum control and comfort when using
• All products are VDE tested up to 1000V AC or 1500V DC to ensure your safety

Typical Applications
• Construction
• DIY
• Electrical

Standards
• DIN 7438
• DIN EN 60900

For use on mild steel or other non ferrous materials, these aviation snips cut from tight curves to straight. Available in both a left and right handed design, the product is manufactured from drop forged chrome vanadium steel with ground blades (54 - 58HRc). The double fulcrum compound action amplifies the pressure applied for easier cutting of up to 1.2mm cold rolled steel sheet. Each product also has a spring loaded, self-opening action for fast, effortless feed and single-handed operation. Complete with safety features such as anti-slip guards and a thumb lock that ensures the jaws stay closed when not in use.

Features and Benefits
• Available as either a left or right handed design to suit your handedness
• Drop forged chrome vanadium steel, ground blades offer durability and hold a good cutting edge even with extensive use
• Double fulcrum compound action amplifies the pressure applied for easier cutting
• Spring loaded, self-opening action allows for fast, effortless feed and single-handed operation
• Anti-slip guards offer extra safety when cutting
• Thumb lock ensures the jaws stay closed when not in use to avoid accidental cutting or injury
• PVC grip handles bolster user comfort, control and grip when using

Typical Applications
• Construction
• Engineering
• DIY

Manufactured from forged and hardened steel, these ring slogging spanners also possess machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners, the product is available in a variety of metric sizes to ensure you find the correct size for your needs.

Features and Benefits
• Forged steel construction makes for a durable product
• Flat striking faces enable the product to be struck with a hammer if needed
• Corrosion-resistant finish bolsters product longevity
• Available in an array of sizes to suit varying specifications

Typical Applications
• Automotive
• Construction
• Plumbing

Standards
• Conforms to DIN 7444

Insulated Single End Ring Spanners
Chrome vanadium single ended open jaw spanners. Spanner dimensions conform to DIN 7446. Fully insulated to conform to VDE 0680/201 and EN 60900:2012 standards for safe electrical applications up to 1000V.