Our submersible pumps often go to work where centrifugal, progressive cavity, lobe, and chopper pumps have failed. Their unique design and our state-of-the-art technology tackle even the toughest applications with ease.

For use with Kennedy grease guns and all other hydraulic grease equipment.

With a chrome finish, this oil suction gun is suitable for rapid draining or filling of oil and other non-corrosive liquids. Possessing a working pressure of 90psi/6.2bar and supplied with a flexible 275mm spout.

Features and Benefits

• 500cc capacity allows you to effectively drain or fill without having to release often
• Chrome finish is classic and aesthetically pleasing
• Comes with a 275mm spout for easy draining

Typical Applications
• Engineering
• Automotive

Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.

Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost

Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)

Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot