Pump & Lubricants
Kennedy Red-Hot-Dip Hot Dip, Bar, Translucent, 1 Pcs
Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.
Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost
Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)
Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot
Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost
Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)
Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot
Download
Produk Lainnya
For use with Kennedy grease guns and all other hydraulic grease equipment.
Cantilever pumps are ideal for moving abrasive materials and slurries, as only a portion of the pump is located under the fluid. The seals, bearings, bushings, and suction check valves are all outside of the liquid, preventing the material from degrading or interfering with them.
Our cantilever pumps are designed by our engineering team that specializes in handling the toughest pumping jobs. They set the standard for pumping slurries and abrasive materials.
Our cantilever pumps are designed by our engineering team that specializes in handling the toughest pumping jobs. They set the standard for pumping slurries and abrasive materials.
For use with Kennedy grease guns and all other hydraulic grease equipment.
• No close tolerances
• Pulsation-free flow
• Laminar flow
• Non-impinging, preventing degradation
• Does not emulsify or damage delicate and shear sensitive products
• Includes in-line, close-coupled, side-by-side, over-under, and self-priming configurations
• Pulsation-free flow
• Laminar flow
• Non-impinging, preventing degradation
• Does not emulsify or damage delicate and shear sensitive products
• Includes in-line, close-coupled, side-by-side, over-under, and self-priming configurations