With a chrome finish, this oil suction gun is suitable for rapid draining or filling of oil and other non-corrosive liquids. Possessing a working pressure of 90psi/6.2bar and supplied with a flexible 275mm spout.

Features and Benefits

• 500cc capacity allows you to effectively drain or fill without having to release often
• Chrome finish is classic and aesthetically pleasing
• Comes with a 275mm spout for easy draining

Typical Applications
• Engineering
• Automotive

The Kennedy range of line markers are the perfect marking solution ideal for use on car parks, factory/ warehouse floors, playgrounds, sports fields, tennis courts, leisure centres and road surfaces. Its Aerosol delivered formula is suitable for use with stencils or free hand marking.

CFC-free and containing no lead additives, it is safe and convenient to use, capable of marking between 60-100 metres of a 50mm line when used in a standard machine. It is also compatible with most major brand applicators.

Features and Benefits
• Can be used on a variety of surfaces allowing lines to be made in various locations
• One line marker will give between 60-100 metres of a 50mm line when used in a standard machine

• Fully compatible with major brand applicators
• CFC-free formula and no lead additives
• Suitable for stencils, line or free hand marking
• Ideal for use on car parks, factory floors, playgrounds, sports fields, tennis courts and road surfaces
• Available in a range of colours

Typical Applications
• Road Marking
• Leisure Indusrty
• Industrial Floors
Warning
• Flammable- Aerosol

Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.

Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost

Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)

Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot

• No close tolerances
• Pulsation-free flow
• Laminar flow
• Non-impinging, preventing degradation
• Does not emulsify or damage delicate and shear sensitive products
• Includes in-line, close-coupled, side-by-side, over-under, and self-priming configurations