Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.

Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost

Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)

Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot

Suitable for lubricants, diesel and non-corrosive liquids, this lever pump is constructed from a zinc chrome finish steel and is completed with a telescopic suction tube. Suitable for container sizes 60 and 205 litres, the innlet on the pump is 2" BSP and M59 x 5 male thread.





Features and Benefits


• Manufactured from steel for durability


• Zinc chrome finish protects against corrosion and wear and tear


• Can be used with both 60 and 205 litre containers making it a versatile product


• Is compatible with non-corrosive liquids and most lubricants


• Telescopic suction tube allows you to adjust the tube to suit your desired container





Typical Applications


• Automotive


• Engineering

For use with Kennedy grease guns and all other hydraulic grease equipment.

For use with Kennedy grease guns and all other hydraulic grease equipment.