Non-Reinforced Toolroom Cutting Wheels
Thin slitting discs in aluminium oxide grain for all toolroom cutting-off applications.

Conical flap discs are a high performance alternative to sanding discs where surface finish is important. On light gauge sheet metal, the overlapped abrasive strips slowly wear away revealing fresh abrasive.

Features and Benefits
• The overlap design reduces clogging and ensures the disc always cuts effectively and
• Provides a consistent finish throughout disc life
• No backing pads needed

Notes
• Safe to use at 80m/s on any grinder

Standards
EN12413

'B' Shape - Shank Diameter 3mm

Features and Benefits
• All points are aluminium oxide with 'rubenite™' as standard for all general-purpose grinding and deburring on steels and most metals
• Durable and reliable constrution

Typical Applications
• Suitable for portable die and straight hand grinders

Notes
• Shank diameters are metric as listed below with inch sizes available on request
• Maximum speeds are quoted assuming that collet to back of point does not exceed 12.7mm (1/2") and are for guidance only

Shaft mounted abrasive flap wheels are ideally suited for stock removal, deburring, cleaning, blending and finishing on a wide range of materials.

Features and Benefits
• Recessed hub design for maximum access in tight corners
• Suitable for portable power tools, including die grinders, flexible shafts and drills
• Ideal for removal of rust, cleaning up welds and sanding wood prior to painting
• Versatile - Can be used on metal, wood, plastic and fiberglass

Notes
• Always ensure that the speed of the air tool never exceeds the maximum operating speed of the consumable.