Hydraulic fluids are pressure transfer mediums used to transfer the energy stored by way of a hydraulic pump to the hydraulic actuators of cylinders, motors, and other similar devices. To provide precise, accurate, and stable operation of hydraulic equipment, these fluids must have lubricating properties, rust-prevention and corrosion-prevention properties, special temperature and viscosity properties, stability properties, foam suppression properties, and similar properties.

Among these products, HYDOL, our fire resistant hydraulic fluid, is used in hydraulic equipment such as die-cast machines used in the manufacturing of aluminum automotive parts, steel works, and presses. HYDOL protects plant equipment from fires.

HYDOL HAW Series

For hydraulic equipment that handles melted metal such as steel working equipment and die-cast machines, a major fear is the hydraulic fluid catching on fire. To prevent plant fires before they happen, fire resistant hydraulic fluid, which does not catch on fire easily, is used. Among all fire resistant hydraulic fluids, water-glycol type hydraulic fluid exhibits excellent flame resistance as well as having a good balance among all other hydraulic fluid properties.

HAW Red clear liquid : Water-glycol hydraulic fluid with a flame-retardant and high lubricity. Available in a high-pressure area of 14-25MP discharge pressure.

HYDOL AW Series

These products have excellent anti wear properties. A general use type, anti wear type, and high viscosity index type are available. Various viscosity grades are available for each type.

AW-series : Wear resistance hydraulic fluid.

Hot dip protective plastic coating moulds around the component or tool to provide 100% coverage and protect against impact and corrosion.

Features and Benefits
• Hot dip plastic coating moulds itself around the part to provide 100% coverage and protect against corrosion and impacts for up to ten years
• Easy part identity through the translucent coating
• Simple to remove by peeling off
• Once removed, leaves behind a thin oil film to provide short term protection against corrosion
• Removed coatings may be reused saving cost

Notes
• Each single block measures (L)-150mm (H)-50mm (W)-80mm
• Working temperature 130°C to 160°C (for optimum results 140°C to 145°C)

Warnings
• Never directly apply heat to melt the protective dip
• Always use with a suitable melting pot

Glass lining is a proven technique for adding a super-durable, smooth, non-stick surface to metal equipment and components.

Discflo glass lined pumps use the dual-coat glass-lining process developed by Vitco, of PA. The glass lining is a mix of fine borosilicate glass, water, and clay, applied to the base metal substrate at high temperature. Vitco’s dual-coat process allows for extra durability and longevity as the base coat forms a strong bond with the base metal and the cover coat provides the non-stick characteristics.

Our sump and dry fit pumps are the clog-free, low cost, long-lived option that outperforms progressive cavity, centrifugal, lobe, and chopper pumps in even the toughest installations. These pumps are not only powerful but incredibly versatile.