Stainless steel wire scratch brushes are used on stainless steel and aluminum fabricated products - predominantly in stainless steel welding processes where the use of an ordinary wire scratch brush would create the risk of contamination of the weld. Hardwood handle.

Features and Benefits
• Very durable steel wire bristles
• Highly cost effective

Manufactured to assure operator safety and optimum performance. For use with all portable angle grinders.

Features and Benefits
• Highly effective aluminum oxide abrasive - cuts faster for longer
• Multiple disc sizes available, to suit any need
• Ultra-strong Reinforced Resinoid bond provides strength and operator peace of mind

Typical Applications
• Designed for use on alloyed and unalloyed construction steel, steel profiles, tank construction and fabrication, welding and fabrication
• 300mm discs can be used on Suitable Disc Cutting saws
• For use with all appropriate handheld angle grinders
• Cutting discs must never be used for grinding and must always be presented to the work piece at an angle of 90°
• Not to be used for wet cutting

Standards Met
• EN12413

York conical flap discs are a high performance alternative to sanding discs with the advantage over depressed centre grinding discs on light gauge sheet metal where surface finish is important. The overlapped abrasive material wear away revealing fresh abrasive, ensuring the discs always cuts effectively and reduces clogging and providing a consistent finish throughout the disc life. The fibre backing allows for use without backing pads and makes the discs safe to use on any grinder up 80m/s speeds.

Features and Benefits
• Overlapped abrasive material wear away to reveal fresh abrasive ensuring effective cuts and reduces clogging
• Fibre backing allows for use without backing pads and makes the discs safe for use on any grinder

Typical Applications
• Construction
• Automotive
• Manufacturing

Standards
• EN12413

Spiral wound with tear-resistant backing fabric.

Features and Benefits
• For grinding and finishing edges, profiles, welded seams.
• To be used on designated rubber drum holder
• Maximum permitted peripheral speed of 30m/s
• P60 = Coarse, P80 = Medium, P150 = Fine.