High-quality PTFE tape, specially designed for binding, sealing and repairing hot and cold water pipes.

Features and Benefits
• Long-lasting design
• Highly durable
• Will not peel or tear easily

Standards
• BS 6920
• BS 7786

These Pull/Push measuring tapes are ideal for all round use. With a spring blade return, self-adjusting hook for internal and external reading, both metric and imperial readings all houses in an ABS casing, the product is designed to withstand punishing environments. The end hook has two rivets, graduated with 1/32in., 1/16in. and mm. Available in two lengths to suit your preference.

Features and Benefits
• Body is manufactured from ABS impact resistant plastic making for an extremely durable product
• Steel blade has a lacquer coating to protect it from damage
• Spring blade return allows the blade to easily be guided back into the housing when measuring is complete
• Each product has both metric and imperial graduations to suit your preferences and needs
• Available in two sizes to suit your requirements
• Self-adjusting end hook allows for both internal and external measuring

Typical Applications
• DIY
• Engineering
• Construction

Standards
• EEC Class II for Accuracy

Volt-tested to ensure safety on or near electrical equipment up to 1000V AC or 1500V DC, this range of VDE insulated screwdrivers is suited for electrical use. The blades are insulated with magnetic, parallel tips. Slotted head screws are the most commonly used screw. The tip of the screwdriver should be of the same width as the slot in the screw head and fill it as well, to minimise slipping. The product is finished with a high grip handle and is available in a range of sizes.

Features and Benefits
• Magnetised tips allow you to effectively hold fasteners in place to apply torque accurately
• Available in a range of sizes to suit your needs
• High grip handles ensure maximum control and comfort when using
• All products are VDE tested up to 1000V AC or 1500V DC to ensure your safety

Typical Applications
• Construction
• DIY
• Electrical

Standards
• DIN 7438
• DIN EN 60900

Manufactured from forged and hardened steel, these ring slogging spanners also possess machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners, the product is available in a variety of metric sizes to ensure you find the correct size for your needs.

Features and Benefits
• Forged steel construction makes for a durable product
• Flat striking faces enable the product to be struck with a hammer if needed
• Corrosion-resistant finish bolsters product longevity
• Available in an array of sizes to suit varying specifications

Typical Applications
• Automotive
• Construction
• Plumbing

Standards
• Conforms to DIN 7444